User manual

Conversion of the Interlink Controller to Mode 1
2
Lift up lever and remove from pivot shaft as shown.
Re-attach the lever on the opposite side as shown.
Pivot lever down as shown
Re-attach spring in reverse order from how it was
originally removed.
Re-attach spring to lever, lower hook first
Attach other end of spring to upper hook as shown
Screw the ratchet plate on the opposite side as shown
This is how the finished modification should look. Next,
carefully replace the controller’s rear panel and re-
secure with the screws. Finally, select the Mode1 option
from the drop down menu which is part of the RealFlight
software and the conversion is complete.
8.
9.
10.
11.
12.
13.
14.
15.