Operating instructions

Commissioning your fire
Carefully unpack your electric fire, it will consist of:
Electric fire.
Cast ashpan cover ( Except Harmony Trim )
Bag of coal
Remote Control Handset
A fixing kit.
Position the electric fire in the intended position. For stability you must fix the fire into position
using the fixing kit, this is to ensure that the appliance will not fall forward. It is not usually
necessary to have the wire taut.
Using the wall plug, attach the eye-bolt to the wall or the back of the fireplace behind the fire.
Screw the fixing screw and washer partway into the hole shown in the diagram. Wrap one end
of the wire half way around the screw and tighten so the wire is trapped between the washer
and the chassis. Now pass the other end of the wire through the eye bolt. Thread the wire
through one of the two fixing holes in the other side of the chassis, position the fire, then pull
through the wire to take up the slack and thread the wire all the way back through the other
hole. Check it is secure by tipping the fire forwards so the wire is supporting the weight. Give
it a small tug to ensure that it is secured.
Place the coals on the fibreglass fuel bed, putting thinner pieces down the front behind the
bars first and then putting a layer across the top of the bed. If for any reason you
need more coal it is quite acceptable to use normal washed coal.
Position the ashpan cover between the legs of the cast front. (Except Harmony Trim)
Controls.
There is a main isolation switch on the left hand side of the air outlet grill, under the
Magigo logo.
Control switches are located at the top right of the appliance under the canopy (refer
to picture →).
There are two buttons on the fire, ON/C/H and OFF. There is also a thermostat
above the buttons.
To switch on the appliance, make sure the main isolation switch is in the on ‘I’ position
and press the ON/C/H button. This will start the flame effect only. To turn on the cold
fan, press the ON/C/H button again and turn the thermostat up to 10. To turn on the
heater, press the ON/C/H button again and turn the thermostat up to 10. The heater
is now on and controlled by the thermostat.
At any time the fire can be turned off using the OFF button. You will then need to
press the ON/C/H button once to reset.
These controls are duplicated on the handset provided.
Be vigilant and keep the handset out of reach of children or other potential risks.
Due to the location of the infrared sensor, the remote works best from a position predominantly in front of the appliance.
It should work from a distance of approximately 10 to 12 feet.
Thermostat
The heater is automatically controlled by a thermostat to regulate the room temperature. The easiest way to set the
thermostat to your level of comfort is as follows:
a. Turn the heater on by following the instructions above.
b. Leave the heater running until the room has reached your desired comfortable temperature.
c. Slowly turn the thermostat down until it clicks and the heater fan stops.
d. The heater will now cycle on and off to keep the room at the chosen temperature. Each time the heat is turned on, it will
return the room to this preset temperature and then start cycling on and off. Should you wish to raise or lower the room temperature,
i.e. during particularly cold spells, simply turn the thermostat up or down accordingly.
Note: The thermostat switches the heater fully on or fully off as the room temperature fluctuates. You do not get 30% of the heat
when the dial is turned 30% of the way round and 70% when it is turned 70% of the way round.