Operating instructions

Thank you very much for purchasing a Magiglo electric fire. Please spend a couple of minutes reading these instructions
before using the appliance, they are to ensure your safety and convenience.
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock
and injury to persons. These include the following:
Installation.
Read all the instructions before using this heater.
Do not locate this heater immediately below a socket outlet.
Do not use this heater in the immediate surround of a bath, shower, or swimming pool. Avoid any contact with water.
Do not cover this heater, or allow curtains etc to obstruct the air inlet or outlet, otherwise there is a risk of overheating.
Do not lead the cable in front of the air outlet.
Do not trap the cable. Ensure that the fire is not standing on the cable.
Do not use an extension cord because the extension cord may overheat and cause a risk of fire.
Before use, the appliance must be securely fixed by the method described in the following pages. Until it has been fixed in
place, do not leave it in a location where it could be accidentally knocked over by children or pets etc.
Do not permanently fix the appliance, it will need removing for servicing.
Parts of this heater are hot when in use. To avoid burns, do not touch hot surfaces.
This appliance must not be used by children or other persons without assistance or supervision if their physical, sensory
or mental capabilities prevent them from using it safely. Children must be supervised to ensure that they do not
play with or touch the appliance. Use an approved fixed fire screen or safety guard if there is any chance that the
appliance could be inadvertently touched.
Do not run the cable under a carpet or rug etc. Arrange cable away from traffic areas and where it will not be tripped over.
Extreme caution and a guard is necessary when any heater is used near children, the elderly or the infirm and whenever
the heater is left operating and unattended.
Do not use outdoors.
Do not operate any heater with a damaged cable or plug or after the heater malfunctions, or after it has been dropped or
damaged in any manner. Return the appliance to an authorised service agent for examination and repair.
Do not insert or allow foreign objects to enter the appliance as this may cause electric shock, fire, or damage to the
appliance.
This is an imitation log and flame effect electric fire and must not be used as a real fire.
Do not sit or put loads on top of the appliance.
Switch off and unplug the appliance when not in use.
This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Keep combustible materials, such
as furniture
pillows, bedding, papers, cloths and curtains at least 0.9m from the front of the heater and keep them away from the sides
and rear.
Always unplug heater when not in use.
SAVE THESE INSTRUCTIONS
Your fire will come with two spacers attached.
To use freestanding, leave the spacers attached on the rear of the
front frame.
To use semi-inset remove one of the spacers by removing the four
screws.
To use fully inset remove both spacers by removing the four screws
On both spacers.
WARNING: Do not inset this appliance into an open chimney, the draw of the
chimney will cause the heater to cut out. Block off the chimney first or leave
the spacers on to position the appliance in front of the fireplace opening.