user manual

Step One
figure 1
 Set Base (1) on a flat, carpeted surface.

Set Left Side Panel (2) agianst the mounting
block at left end of Base so back edges
align, attach with a wood screw.

Set Left Trim Panel (2A) against
the Left Side Panel. Attach to the
Left Side Panel with screws through
the four holes in the mounting strip.
Then attach to Base through holes
in mounting blocks on base.

Repeat using Right Side Panel
(3) and Right Trim Panel (3A) at
right side of Base.
figure 1
Parts List
Number Description Part Number Quantity
1 Base 8001 1
2 Left Side Panel 8002 1
2A Left Trim panel 8002 1
3 Right Side Panel 8003 1
3A Right Trim Panel 8003 1
4 Center Panel 8004 1
5 Top 8005 1
not shown
1" Screws 9713 Bag
Firebox Clips 1075 2
8000-1 Rev.042006
1
2
2A
8000 Pristine Instructions
Tips For Assembly
Before assembly, locate instructions and
hardware. Take out all parts and compare them
to the photograph and the assembly
illustrations. Be sure you have all parts
identified.
Check for screws that are wrapped in the
packaging to be sure you don't discard them.
You may have extra screws.
A helping hand is always good. Assemble
fireplace with an adult assistant if possible.
The cement log is heavy. Put the fireplace in
the desired location before inserting cement
log.
Use caution not to over tighten screws.