Owner's Manual

Fig. D

Step 5: Drill 4 holes 5/16in(8mm) in diameter and 2.2in(56mm) deep

on the marked locations. For the holes that do not hit a stud, use the

supplied wall anchors. Install the wall anchors into the holes and gently

tap them into place with a hammer until the ﬂange of the wall anchor

is ﬂush with the wall surface. See Fig. E.

Fig. E

Step 4: Select the wall location where you want to hang your electric

ﬁreplace. Hold the mounting bracket to the wall and draw a horizontal

line using a level and mark 4 drill holes for the anchor screws.

See Fig. D

INSTALLATION (Cont’d.)

56 mm

Fig. E