Installation guide

-7-
Firebox Installation:
Pearl (Glass Trimmed) Fire
For Pearl or other Glass trimmed fires, the
left and right trim hanging tabs need to be
removed to provide a flat surface for the
glass to mount to.
Timber Framing
Cavity Design
NOTE: The firebox and flue need to be installed before the wall can be lined!
It is recommended that the cavity lintel is left off until the flue and firebox have been
installed. (Allow approx 1200mm clearance above the firebox)
Remember that both gas and electricity are required within the cavity
(Refer to Notes on
Installation, page 5)
It is recommended that the fire be installed on a solid platform. If this is not possible then there must be support
provided for at least the first 20mm, and for 45mm at 307mm from the front finished face of the cavity.
• If the fire is to be installed with a
hearth, either on the floor or
cantilevered, it is important that
the finished top of the hearth is
flush with the floor of the
installation cavity. For the best
finish, allow for the hearth to fit
under the firebox by 5~10 mm.