Installation guide

-5-
Notes on Installation:
Gas Supply
A suitable gas supply needs to be provided to the Left hand rear corner of the installation cavity. The pipe sizing
should be calculated to supply at least 40MJ/h
Allow sufficient pipe to make the connection as shown below:
Electrical Supply
The Firebox is supplied with a power lead approx 1.8 m long. This needs to be connected to an isolating wall
switch, provided by an electrician, located preferably to the right of the Firebox, facing into the room, not inside
the framing cavity. This supply is used to isolate all power for the electronic fires or to control the fan in the
manual fires. The power cord is designed for a 230/240V a.c. 10 amp supply. Electrical connection must
comply with AS/NZS 3000.
note: the manual fire will operate without power but the fan will not, the electronic version will not operate at all
without power.
Clearances
The fire must be installed with the shown minimum clearances to combustible materials
Electronic Manual
A 295 250
B 158 172