Installation guide

-4-
Specifications:
Make: Real Fires
Models: RF800M(N/P), RF800E(N/P), Modern, Classic, Minimal and Pearl
Trim Options: Cast Grates, Stainless Steel and Powder Coated Steel, Glass
Burner Media: Ceramic Logs/Coals and Vermiculite, Ceramic Pebbles, Crushed Glass
Gas Types: Natural Gas, Propane (Australia only)
Description: Indoor Decorative Fire
Test standards: NZS 5262:2003, AS 4558-2000, AS/NZS 3100:2002
AGA Approval No: 7512
Dimensions:
**
**800
375
410
**
627
230
Pearl
Firebox Dimensions
Trim Dimensions
720
990
1
3
870
Minimal
Modern & Classic Grate
9
1
0
1
5
680
900
675
* APPROX, DEPENDS ON
BENDS
** FOR MASONRY
INSTALLATIONS ONLY
658
364 *
9
10
1
5
680
Flue: 200 mm stainless steel inner/ 250 mm galvanized steel outer
200mm Flexi liner (masonry only)
Minimum of 2.4 metres of flue, 3.6 metres if off-set bends are used
Flue Cowl: AGA Approved 200 mm Flue Cowl
Gas Connection: 3/8" BSPF Gas Flare onto gas control
Power: 230/240V a.c. 50hz, 1 Amp
)launam( deeps elgnis )cinortcele( deeps 2 ;laitnegnaT :naF
Gas Types: Natural gas Propane
Inlet Pressure (nominal) 1.13 kPa 2.75 kPa
Supply Pressure (min/max) 1.0/5.0 kPa 2.0/3.5 kPa
Gas Rate: (high/low) 40/28 MJ/h 40/25 MJ/h
Pressure (high/low) 0.80/0.40 kPa 1.6/0.60 kPa
Pilot Injector: 0.45 mm 0.3 mm
Main Injector: 2 x Ø 2.2 mm 2 X Ø 1.45 mm
Primary aeration: 14.5mm Sleeve No Sleeve (12mm sleeve for pebbles or crystals)
Burner: Bunsen type atmospheric
launaM cinortcelE
Gas Control: SIT 845 with SIT 579. DBC modulating control SIT 630
Ignition: Electronic Battery continuous
Flame Monitoring: Flame rod Thermocouple
Control: Electronic Control with IR remote Manual Adjustment