User guide

Rack information C–11
Hitachi Unified Storage VM Block Module Hardware User Guide
5. Install the M5 screw at the rear of the cabinet and tighten to the
following torque: 1.0 N-m, 8.85 in-lbs. If a torque wrench is not
available, tighten the screw to hold the rail firmly in place. Be careful not
to overtighten.
6. Install another M5 screw at the front of the cabinet and tighten to the
following torque: 8.85 inch lbs.
7. Repeat the previous step to install the rail kit on the opposite side. The
following four illustrations show various views of the installed rack-
mount rail support installation kit.
The following figures show the left side of the rail assembly and views of the
rack-mount rail support installation kit
Figure C-6: Installing the rack-mount rail kit