Installation manual

42 |
Software setup | HDS Gen3 Installation Manual
Enabling CZone functionality
If the Czone device(s) are not automatically detected, it is possible
to manually enable CZone in the Advanced Settings page, under
System.
Once CZone is enabled, a CZone icon appears in the Settings menu.
Assigning the dipswitch setting
Every Lowrance product capable of controlling and viewing CZone
devices must be assigned a virtual dipswitch setting. This setting is
unique for each device. Typically, it is set after the con g  le already
exists on the CZone system, but it may also be set in advance. To do
so, access the CZone menu on the Settings page.
When the con g is already available on the network, it will
immediately commence uploading to the HDS Gen3 once the
dipswitch is set. Allow this to complete, without interruption.
Setting CZone to display at startup
With this option selected, the CZone control page will be shown
 rst, every time the HDS Gen3 is powered up.
CZone backlight control
Enabling this will cause the HDS Gen3 to synchronize its backlight
setting with that of any CZone Display Interfaces set up to share
backlight settings.
 note: CZone Con g also needs to have the HDS Gen3 set as a
controller.
Import and backup a con g  le
The  les page may be used to import CZone con g  les, or export a
copy to a Micro SD card. Importing will overwrite the existing  le on
the HDS Gen3 and all connected CZone devices.
For further information see “Backing up and Importing user data” on
page 50