User guide

4.3 Wireless

4.3.1 Basic

Wireless Basic Settings

 Disable Wireless: Disable or enable the wireless network. (Enabled = Default)

 Mode: Select the wireless network mode. (Default = B+G+N)

 Use Type: Choose the type of wireless network job Default = AP

 SSID: Identifies you wireless network. (Default = WR300NQ

 Channel Width: Wireless channel operating frequency bandwidth. (Default = 40 MHz)

 Control Sideband: The sideband can be set to upper (High) or lower. (Default = High)

 Associated Clients: Display the wireless clients connected to the router.

 Broadcast SSID: Choose to broadcast the SSID, or hide it from others. (Default = Enabled

 Channel: Select the 802.11x channel you wish to use. (Default = 9)

 Enable Universal Repeater Mode: Allows the router to act as an 802.11x repeater mode.

(Default = Disabled)

 SSID of Extended Interface: If you use repeater mode, you must assign another SSID to

access the repeater instead of the originating routers SSID. (Default =

802.11bgn-SSID-Repeater)

4.3.2 Advanced

Wireless Advanced Settings