Owner manual

.
Next, reinstall strut assembly into vehicle and
secure top with new hardware, OE on the
lower. Carefully raise lower control arm into
pockets and torque hardware to spec. Re-
connect ABS line by routing it over the upper
a-arm away from new bump stop bracket.
Reconnect sway bar end link. Repeat process
on opposite side. Recheck all hardware and
align vehicle.
www.ReadyLIFT.com
Phone [phone]
Installation Instructions (69-1030)
Drop lower control arm out from frame pockets. Now, remove upper strut mounting nuts.
Remove strut assembly from vehicle.
Attach new strut extension with OE hardware.
Attach bump stop/bracket to frame hole w/ new hardware Align bump stop under a-arm, fit inside washer plate to frame
Attach new hardware and torque to spec.