User Manual

.
Break loose tie rod/upper ball joint
No photo
www.ReadyLIFT.com
Phone [phone]
Installation Instructions (69-1035)
Disconnect tie rod end nut and break loose with hammer Loosen upper ball joint nut and break loose with hammer.
While supporting suspension, remove upper ball joint nut Slowly lower suspension and remove coil spring.
Remove upper isolator and replace with new ReadyLIFT hat. Reinstall coil spring and properly clock in lower control arm.
Carefully lift suspension enough to engage upper ball joint. Reconnect brake calipers, sway bar end links, and tie rods.