User Manual

www.ReadyLIFT.com - Phone: [phone]
Tubular Control Arm 06 Up Dodge Ram 1500 67-1500
4 10-14-15 MMC
Remove the factory upper control arm from the vehicle.
(FIG 7)
Install the control arm bushings and sleeves into the Readylift control
arms using the grease provided in the kit.
Install the Readylift control arms into the frame using factory hard-
ware. Do not tighten at this time.
(FIG 8)
Install the upper ball joint to the knuckle using the provided thick
washer, and castle nut. Torque to 70 ft-lbs. Install the provided cot-
ter pin. Grease the ball joint.
(FIG 9)
Install the ABS clip into the control arm and reconnect the electrical
connector.
(FIG 10)
Install the wheels and lower the vehicle to the ground. Torque the
lug nuts to the wheel manufacture specs. Jounce the vehicle to get
the suspension to settle. Torque the upper control arm to 120 ft-lbs.
Reconnect the vehicle power source ground terminal.
Take the vehicle to a reputable alignment shop and have alignment
set. Recommended alignment specs at the bottom of the final page.
***Final install and checks***
Recheck that all hardware is of proper torque values and all
electrical connections are hooked up. Start vehicle and verify that all
dash warning lights are off. Cycle the steering wheel from lock to
lock to check for any interference of steering intermediate shaft,
steering extension, steering u-joint. wheels, tires, brake lines, hoses,
wires, ect and ensure adequate clearance through out the suspension
cycle. Adjust as necessary.
FIG 6
FIG 7
FIG 8
FIG 9
FIG 10