User Manual

ReadyLift

(Part# 66-5075) Strut Extension, Installation Instructions

Toyota Tundra New Body Style 2WD & 4WD

ReadyLift Suspension Inc.

3201 W. Macarthur Blvd. Santa Ana, CA, 92704

Tol l F r e e ( 8 0 0 ) 5 4 9 - 4620 Local (714)862-296 8 F a x ( 7 1 4 )86 2 - 2972

Loosen and remove the two 22mm bolts that

connect the lower ball joint to the spindle.

Please take caution as the lower control

arm will swing down as soon as you

remove the lower ball joint bolts.

Holding the Strut with one hand remove the

four 14mm upper strut mounting nuts.

Remove the strut, being careful not to

damage the CV Boot on 4WD models.

Install the ReadyLift

strut extension

and torque to factory specs.

Reinstall strut into vehicle and install the new nuts provided,

but do not tighten.

Using a jack, raise the lower control arm and guide both the

lower strut mount and the sway bar end link into their re-

spective pockets. Install the lower strut mounting bolt and

nut, torque to factory specs. Use thread locker if necessary.

Lower ball joint bolts bolts

Use of a pry bar and hammer may be need to align mounting

holes for the end link bolt. Install 19mm bolt and torque to

factory specs.

10.

11.

Using a 14mm wrench, loosen but do not remove

the four upper strut mounting nuts.

Total of 4 nuts