Other Content

ReadyLift® (Part# 66-5055)Strut Extension, Installation Instructions
Toyota Tacoma 6 lug, 2wd & 4wd
ReadyLift Suspension Inc.
3201 W. MacArthur Blvd., Santa Ana, CA 92704
Tol l F r e e ( 8 8 8 ) 9 2 2 - 2 2 9 4 L o c a l (714 ) 8 6 2 - 2 9 6 8 F ax ( 7 1 4 ) 8 6 2 - 2 97 2
7 / 2 7 / 2 0 1 0
Please read instructions thoroughly and completely before beginning installation.
Installation by a trained mechanic is recommended.
6. Reinstall the strut assembly in its stock
location. Leave the three upper strut mounting nuts
loose Raise the lower control arm and install the
lower strut mounting bolt and nut. Use a floor jack to
raise the lower control arm up in order to get the
lower ball joint bolts installed. Be sure to use a
thread locker on the lower ball joint bolts.
Be sure to tighten all nut and bolts to factory specs.
7. Repeat steps 2 through 7 on the Driver’s Side
of the vehicle. Follow each step closely, making
sure to double-check the torque on all fasteners.
Differential Drop Installation
1. Position a floor jack under the front differential.
Raise the pad so that it is touching the diff.
2. Remove the factory 19mm differential mounting
nuts and bolts. The OEM washers will be reused.
3. Install the 1” spacers between the differential
supports and the front cross-member. Install the
new bolts with factory washers and the new nuts
and washers. Torque to factory specs.
4. Re-install the skid-plate, use two OEM bolts for
the front and the supplied and torque the bolts to
factory specs. Re-install the wheels and torque to
factory specs.