Other Content

ReadyLift® (Part# 66-5055)Strut Extension, Installation Instructions
Toyota Tacoma 6 lug, 2wd & 4wd
ReadyLift Suspension Inc.
3201 W. MacArthur Blvd., Santa Ana, CA 92704
Tol l F r e e ( 8 8 8 ) 9 2 2 - 2 2 9 4 L o c a l (714 ) 8 6 2 - 2 9 6 8 F ax ( 7 1 4 ) 8 6 2 - 2 97 2
7 / 2 7 / 2 0 1 0
Please read instructions thoroughly and completely before beginning installation.
Check www.readylift.com for any updated installation instructions.
installation by a trained mechanic is recommended.
Prior to lifting the vehicle, that you measure the stock height of
the vehicle so that you have a base line to check after the kit
has been installed. Measuring the vehicle from the
bottom of the wheel to the lip of the fender is recommended.
Position truck on a flat surface and lift vehicle by the frame so that the front wheels are off the ground.
Use a floor jack and jack stands or a (2) two post lift if available and remove both front wheels.
2. Starting from the passenger side, loosen the up-
per and lower strut mount nuts.
1. Remove the skid plate by unbolting the four
12mm bolts that hold it on.
4. Remove the lower strut mount nut and bolt.
Push the lower control arm down.
3. Loosen, but do not remove the 19mm lower con-
trol arm nut and bolt, Remove the 19mm lower ball
joint bolts.
5. Remove the three upper strut mounting bolts.
Remove the strut from the vehicle and mount it in a
bench vise. Install the ReadyLift
®
kit, and torque
fasteners to OEM specifications. Note the shape of
the ReadyLift
®
spacer; the strut will be rotated 180
degrees when reinstalled.
Lower Ball joint bolts