Installation guide

outlined in this guide. If the vehicle starts when performing the Neutral Safety

Shutdown Circuit test, the remote start unit has not been properly installed. The

remote start module must be removed or properly reinstalled so that the vehicle

does not start in gear.

OPERATION OF THE REMOTE START MODULE IF THE VEHICLE STARTS IN

GEAR IS CONTRARY TO ITS INTENDED MODE OF OPERATION. OPERAT-

ING THE REMOTE START SYSTEM UNDER THESE CONDITIONS MAY RESULT

IN PROPERTY DAMAGE OR PERSONAL INJURY. YOU MUST IMMEDIATELY

CEASE THE USE OF THE UNIT AND SEEK THE ASSISTANCE OF AN AU-

THORIZED DIRECTED DEALER TO REPAIR OR DISCONNECT THE INSTALLED

REMOTE START MODULE. DIRECTED WILL NOT BE HELD RESPONSIBLE OR

PAY FOR INSTALLATION OR REINSTALLATION COSTS.

Caution

This product is designed for fuel injected, automatic transmission ve-

hicles only. Use of this product in a standard transmission vehicle is

dangerous and contrary to the product's intended use.

Safety Check

Before vehicle reassembly, the remote system must be checked to en-

sure safe and trouble-free operation. The following test procedure must

be used to verify proper installation and operation of the system. The

installation must be completed before testing, including connection to

the brake switch and hood switch.

1. Test the BRAKE shutdown circuit: With the vehicle in Park (P), ac-

tivate the remote start system. Once the engine is running, press

the brake pedal. The engine should shut down immediately. If the

engine continues to run, check the brake circuit connection.