Installation guide

Warning! Safety First

The following safety warnings must be observed at all times:

Due to the complexity of this system, installation of this product must be done

properly according to instructions with safety always considered. Failure to

properly install this system and its safety features may result in personal injury,

property damage or both.

When properly installed, this system can start the vehicle via a command signal

from the remote control. Therefore, never operate the system in an enclosed area

or partially enclosed area without ventilation (such as a garage). When parking

in an enclosed or partially enclosed area or when having the vehicle serviced,

the remote start system must be disabled using the installed toggle switch. It is

the user’s sole responsibility to properly handle and keep out of reach from chil-

dren all remote control devices to assure that the system does not unintentionally

remote start the vehicle. THE USER MUST INSTALL A CARBON MONOXIDE

DETECTOR IN OR ABOUT THE LIVING AREA ADJACENT TO THE VEHICLE.

ALL DOORS LEADING FROM ADJACENT LIVING AREAS TO THE ENCLOSED

OR PARTIALLY ENCLOSED VEHICLE STORAGE AREA MUST AT ALL TIMES

REMAIN CLOSED. These precautions are the sole responsibility of the user.

Use of this product in a manner contrary to its intended mode of operation may

result in property damage, personal injury, or death. (1) Never remotely start the

vehicle with the vehicle in gear, and (2) Never remotely start the vehicle with

the keys in the ignition. The user must also have the neutral safety feature of the

vehicle periodically checked, wherein the vehicle must not remotely start while

the car is in gear. This testing should be performed by an authorized profes-

sional Directed dealer. If the vehicle starts in gear, cease remote start operation

immediately and consult with the authorized Directed dealer to ﬁx the problem.

After the remote start module has been installed, perform the Safety Check