Installation guide

the engine will shut down.

While the vehicle is running during remote start operation, the system

monitors the ve hi cle and automatically shuts down the engine if it receives

any of the following shut-down inputs:

• The brake pedal is pressed.

• The hood is opened.

• The shutdown toggle switch is put into the Off position.

• The pre-programmed run time has elapsed.

• Remote control button is pressed and held for 3 seconds.

Valet Take-Over

The Valet Take-Over feature allows the vehicle to remain running after

the key has been removed from the ignition. This feature is useful for

occasions when you wish to exit and lock the vehicle for short periods

of time, but would like to leave the engine running and the climate

controls on.

To perform Valet Take-Over:

1. Before turning off the engine, press and release the button on the

remote control for 1 second.

2. Turn the ignition key to the Off position. The engine will stay run-

ning until the pre- pro gram med time has elapsed or a shutdown

input is received. (See the previous Remote Start section for a

complete list of shut-down inputs.)

Important: This feature will not work if the brake pedal is being

pressed.