Installation guide

10
© 2010 Directed Electronics. All rights reserved.
Remote Control Programming
1. Turn key to the ON position
2. Within 5 seconds, press and release
Control button one time.
3. Within 5 seconds, press and hold the Control button. The LED will
flash one time to confirm entry into remote programming.
4. Press the button on the remote control.
5. The LED flashes to confirm the remote has been programmed.
6. Release the Control button, and turn the key to the Off position.
7. The LED turns on solid for a while to confirm that remote program-
ming has been exited.
The programming routine exits if any of the following occurs:
• The ignition is turned off
• There is no activity for 30 seconds
• The Control button is pressed too many times