Installation guide

Tach Learning

Note: Tach learning requires H3/2 (Violet/White) wire to be con-

nected to Tach. If using Virtual Tach, this procedure is not required and

should not be used.

To learn the tach signal:

1. Start the vehicle with the key.

2. Within 5 seconds, press and hold the Control button.

3. After 3 seconds the LED will light constant when the tach signal

is learned.

4. Release the Control button.

Reset and Deletion

If a feature/virtual tach needs to be reset or the remote controls need to

be deleted, use the following procedure.

1. Turn the ignition to the On position (The heavy gauge pink wire

must be connected).

2. Within 10 seconds, press and release the Control button: 2 times

if you want to delete remote controls, 3 times to reset features or 4

times to reset virtual tach. These features are described next.

Delete remote controls: This feature erases all remote controls

from the memory of the system. This is useful in cases when a

remote control is lost or stolen. You can program new remote

controls to the system, see Remote Control Programming section

of this guide.

Note: This does not reset the programmed features of the sys-

tem or reset the Virtual Tach setting.

Reset Features: This resets all features of the system to the fac-