Product specifications

Chapter 3 Installing HA-680 driver
HA-680_V04
- 60 -
3-5-3 Connecting power cables
The terminal block for the power is located on the front panel of the HA-680 driver.
Shown the figure to the right, strip the end of wires of the power supply cable and
the motor cable, and connect wires to each terminal firmly. When working the
connection cable, be careful not to damage the wire.
To prevent malfunction of the HA-680 driver due to external noise, insert the “noise filter” into the power
line.
The HA-680 driver contains a surge-current-suppress-circuit of capacitor type. Although the circuit
reduces line voltage fluctuation, avoid daisy-chain wiring of the power lines, and connect units with a
main switch.
The HA-680 driver is the DC power input type. Use the power supply with the following power supply
capacity.
Power supply capacity (W)
Driver
Actuator
Continuous rating Instantaneous
FHA-8C 40 120
HA-680-4
FHA-11C 80 240
HA-680-6 FHA-14C 120 360
HA-680-4B
RSF-3A RSF-5A
20 50
The following products are recommended.
Driver
Actuator Recommended AC/DC power supply Manufacturer
FHA-8C JWS70P-24
HA-680-4
FHA-11C JWS120P-24
HA-680-6 FHA-14C JWS240P-24
HA-680-4B
RSF-3A RSF-5A
JWS70P-24
Densei Lambda
HA-680
Main switch
O
t
h
er
device
O
t
h
er
device
Power
O
t
h
er
device
O
t
h
er
device
Power
Good cable management
Bad cable management
Main switch
HA-680
7mm
To supply power, use the secondary-side power supply with
double insulation from the primary side.
WARNING
Model:
MC1.5/5-G-3.81
(
Phoenix contact
)
MP+
MP-
CP+
CP-
AC/DC
converter
Noise
filter
CP+
CP-
MP+
MP-
DC24V
+24V
0V