Product specifications
Chapter 3 Installing HA-680 driver
HA-680_V04
- 53 -
Chapter 3 Installing HA-680 driver
3-1 Receiving Inspection
Check the followings when products are received.
● Inspection procedure
(1) Check the shipping container and item for any damage that may have been caused during
transportation. If the item is damaged, contact us immediately.
(2) There is a nameplate attached to the heat sink of the HA-680 driver.
Check whether the item is the one you ordered by looking at the nameplate. If it is different,
immediately contact the dealer whom it was purchased from.
The model code is interpreted as follows:
(3) Under the [ADJ.] line, the code of the FHA-C series actuator to be driven by the HA-680 driver is
typed. To avoid confusion, group the actuator with its appropriate driver.
(4) The input voltage for the HA-680 driver is identified with the last code of the model code in the
[INPUT VOL.] frame on the label.
24: 24VAC power supply
If the voltage to be supplied is different from the voltage on the label, immediately contact the dealer
whom it was purchased from.
Only connect the actuator specified on the driver label.
The HA-680 driver has been tuned for the actuator specified on the driver label. The
wrong combination of HA-680 drivers and actuators may cause low torque problems or
over current that may cause physical injury and fire.
WARNING
Do not supply voltage other than the voltage specified on the label.
The wrong power supply voltage may damage the HA-680 driver resulting physical
injury and fire.
WARNING
HA-680-4□-24
Nominal current
24 DC24V
4 4A
6 6A
None For FHA-CminiAC24V type
B For RSF supermini series
A
vailable encode
r
In
p
ut volta
g
e
680 series
A
C servo driver