Specifications

Operation Procedures

Modes of Operation:

The Model 600 Single Door Slider window has two modes of operation, Manual and Automatic.

After installation of the Model 600 Manual or Electric Sliding window, completion of the testing procedures

and the installation of the decorative covers, the window is ready for normal use.

The Manual Mode: The opening and closing of the window is done by hand.

(DO NOT OPEN OR CLOSE THE DOOR WITH ANY UNDUE FORCE)

Manual Operations:

1. Unlock the deadbolt on the door.

2. Release the manual latch and push the door open.

3. Push the door closed and allow the manual latch reset.

4. Relock the deadbolt.

The Automatic Mode is reached by turning “ON” the main power to the window. Stepping in and out of

the sensor’s range opens and closes the door.

Automatic Operations:

1. On the controller unit, turn the power rocker switch to the “ON” position.

2. Check that the red portion of the rocker switch is visible and that the red power lamp is

illuminated

3. Break the electronic eye beam or step into the sensor beam path. The red beam break and green

motor run lamps go on.

4. Step out of the beam path and wait 3 to 6 seconds for the door to close. The red motor run lamp

and red close detect lamps will illuminate. After the door close note that the red power lamp and

the current detect lamps are “ON”.

5. If the door does not operate correctly, go to the troubleshooting guide in this manual. If the door

still do not operate properly, then call Ready Access at

1-800-621-5045

6. The door can be operated manually by pulling the manual release located at the top of the door.

NOTE: Turn the power off to the window to prevent any damage to the PCB.

Each operator must read the operations manual before operating the unit.