Specifications

CHAPTER 4 NDA-24213
Page 38
Issue 3.0
Programming the PBX and the D
term
Programming the D
term
Series III ACD Terminal
All other ACD function keys will be programmed on Keys 1 through 16.
8.2 Service Conditions
1. In order for Logon (Key 19) and Break (Key 18) to chime, a speaker key must be assigned to a
Key number between 1-16.
2. The FNC (F1011), Recall (1015), LNR/SPD (F1000), and Answer (F4001) Keys can be assigned to
Keys 1-16.
3. Do not use the MAT command F2, “Copy of D
term
Key”, if your ACD terminals are a mixture of
Series III and Series E sets. The key layouts are different between these two terminals. You can copy
from Series E to Series E, and from Series III to Series III, but you cannot copy from Series E to
Series III.
4. If the first port (level 0) of the card is set to a 1 (Elite) in CM12 YY=17, a PN-4DLCA or PN-4DLCM
card must be installed. If you use a PN-4DLCD card with the first port (level 0) set to a 1 (Elite) in
CM12 YY=17, the ACD Keys will not function and there is no display on the terminal.
5. D
term
series ACD terminals are supported with Series 1800 software CJ0.17 and above.