Specifications

CHAPTER 4 NDA-24213
Page 36
Issue 3.0
Programming the PBX and the D
term
Programming the D
term
Series E ACD Terminal
Key 22 = 1033 Break (OAI Key 1, CMD7 Y=0 OP-Code 187)
Key 23 = F1004 Transfer
Key 24 = F1010 Hold
All other ACD function keys will be programmed on Keys 1 through 16.
7.2 Service Conditions
1. In order for Logon (Key 18) and Break (Key 22) to chime, a speaker key must be assigned to a Key
between 1 and 16.
2. The Feature (F1011), Recall (F1015), Redial (F1000), and Answer (F4001) Keys can be assigned to
Keys between 1 and 16.
3. Do not use the MAT command F2, “Copy of D
term
Key”, if your ACD terminals are a mixture of
Series III and Series E sets. The key layouts are different between these two terminals. You can copy
from Series E to Series E, and from Series III to Series III, but you cannot copy from Series E to
Series III.
4. If the first port (level 0) of the card is set to a 1 (Elite) in CM12 YY=17, a PN-4DLCA or PN-4DLCM
card must be installed. When using a PN-4DLCD card with the first port (level 0) set to a 1 (Elite) in
CM12 YY=17, the ACD Keys will not function and there is no display on the terminal.
5. D
term
series ACD terminals are supported with Series 1800 software CJ0.17 and above.