Specifications

CHAPTER 3 NDA-24213
Page 22
Issue 3.0
Connection Drawings
PN-CC01 Connecting Through a Hub
4. PN-CC01 Connecting Through a Hub
Figure 3-6 PN-CC01 Connecting Through a Hub
STEP 1: The Ethernet cables going to the hub from the PN-CC01 and from the hub to the Server and PCs are
straight-through cables.
STEP 2: The Ethernet cable from the transceiver to the hub goes into a port other than Port 8 of an 8-port hub
or Port 4 of a 4-port hub. The last port in a hub is usually used as an uplink port, connecting to a LAN,
another hub, a bridge, a router, or other such device. Verify this with the manufacturer’s specifica-
tions for the hub you are using, since some hubs use Port 1 for uplink instead of the last Port.
STEP 3: The Ethernet cables from the ACD computer and from the MIS PC can go into any port that is not
the uplink port.
NEAX2000 IVS
PN-CC01
PN-AP01
CallCenterWorX Server
10 Base T Hub
Remote MIS PCs
10 Base T Cable
Ethernet Cables
Interface
Cards
Remote ACD Client