Specifications

NDA-24213 CHAPTER 3
Page 21
Issue 3.0
Connection Drawings
PN-CC00 Connecting Through a Hub
3. PN-CC00 Connecting Through a Hub
Figure 3-4 PN-CC00 Connecting Through a Hub
STEP 1: The Ethernet cables going from the transceiver to the hub and from the hub to the Server and PCs are
straight-through cables.
STEP 2: The Ethernet cable from the transceiver to the hub goes into a port other than Port 8 of an 8-port hub
or Port 4 of a 4-port hub. The last port in a hub is usually used as an uplink port, connecting to a LAN,
another hub, a bridge, a router, or other such device. Verify this with the manufacturer’s specifica-
tions for the hub you are using, since some hubs use Port 1 for uplink instead of the last Port.
STEP 3: The Ethernet cables from the ACD computer (Client or Server) and from the MIS PC can go into any
port that is not the uplink port.
3.1 Straight-Through Pin-out
Figure 3-5 Straight-Through Pin-out
NEAX2000 IVS
PN-CC00
PN-AP01
CallCenterWorX Server
10 Base T
Transceiver
Ethernet Cables
10 Base T Hub
Remote MIS PCs
Hub, Bridge remote MIS PC
TCP/IP via hub
Remote ACD Client
Interface
Cards
Straight-Through
TxD+ 1
TxD- 2
RxD+ 3
RxD- 6
1 TxD+
2 TxD-
3 RxD+
6 RxD
-
NOTE:
1. Pins 4, 5, 7, and 8 not used.
2. Use for going from 10
Base T transceiver to a hub.