Specifications

NDA-24213 CHAPTER 10
Page 225
Issue 3.0
MIS Procedures
Wall Display Board Assignments
Figure 10-14 Wallboard Message Set Window
STEP 4: In the
Message Set
field, enter a name of up to 11 alphanumeric characters, or select an existing
name from the drop-down list.
STEP 5: In the
Board Type
field, select a board type from the drop-down list (for selection see Table 10-1).
STEP 6: Select a
Color
from the drop-down list. (Some board types support only red.)
STEP 7: In the
Message
area, selecting
<EMPTY>
will open a message field containing a number of slots (the
number depends on the board type used). When this field is open, you may:
(a) Enter a message by typing a letter, using the right arrow to move to the next slot, typing the next
letter, and so on. The
Scope
field is inactive for typed messages, but the
Mode
field allows a
choice of 25 display modes (such as Hold, Roll Right, and Twinkle).
(b) Add statistics from the drop-down list.The
Add Statistic
button is activated when the message
field is open. Choose System or Split in the
Scope
field, and the
Mode
field allows a choice of
display modes.
(c) Add a graphic from the drop-down list. The
Add Graphic
button is activated when the message
field is open.The Scope field is inactive for graphics, but the
Mode
field allows a choice of 25
display modes.