User's Manual

22
•Ensurethatyouhavenotsetcallbarringforthephonenumber.
Another caller cannot reach you.
•Ensurethatyourphoneisturnedon.
•Ensurethatyouhaveaccessedtherightcellularnetwork.
•Ensurethatyouhavenotsetcallbarringforthephonenumber.
Another caller cannot hear you speaking.
•
Ensurethatyouarenotcoveringthebuilt-inmicrophone.
•Ensurethatthemicrophoneisclosetoyourmouth.
•
Ifusingaheadset,ensurethatitisproperlyconnected.
The phone beeps and the battery icon ashes.
Your battery is low. Recharge or replace the battery to continue
using the phone.
The audio quality of the call is poor.
•
Ensurethatyouarenotblockingthephone’sinternalantenna.
•
Whenyouareinanareawithweaksignalsorpoorreception,
you may lose reception. Move to another area and try again.
You select a contact to call, but the call is not dialed.
•
Ensurethatthecorrectnumberisstoredinthecontactlist.
•Re-enterandsavethenumber,ifnecessary.
The battery does not charge properly or sometimes the
phone turns itself off.
•
Thebatteryterminals maybedirty.Wipebothgold-colored
contacts with a clean, soft cloth and try charging the battery
again.
•
Ifthebatterywillnolonger chargecompletely,disposeofthe
old battery properly and replace it with a new battery.
FCC Regulations
This mobile phone complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that
may cause undesired operation.
This mobile phone has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can
radiated radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for
help.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user‘s authority to
operate the equipment.
The antenna(s) used for this transmitter must not be co-
Safety & Precaution