User manual

Smart_DP RM 9600 User Manual
Seite 22
G - Configuration of the RDT RM96XX-modem
In order to have the Smart_DP for Radio Modem Series module working together optimally
with the RDT RM96XX radio modem, some configuration must be done to the radio modem.
These settings are absolutely necessary to guarantee the right functionality!
Only the tables of the user configurable settings of the radio modem are fixed below, which are
necessary for the right operation of the coupling module with the modem.
ROTARY SWITCH = 0 / RUN MODE
Irrelevant for modem/Smart_DP coupling, only important for the general configuration of the
RF communication.
ROTARY SWITCH = 1 / TEST
Irrelevant for modem/Smart_DP coupling, only important for the general configuration of the
RF communication.
ROTARY SWITCH = 2 / ADDRESS
Will be changed automatically via serial communication with Smart_DP module. (no manual
configuration needed)
ROTARY SWITCH = 3 / MODE
1 2 3 4 5 6 7 8
PRIMARY MODE OF OPEARTION SERIAL CON-
TROL
REPEATER
ON/OFF
REPET ALL
ON/OFF
AUTO REPEAT
ON/OFF
REPEATER
REMOTE
RS232/
RS485
OFF OFF ASYNC OFF-X-X = REPEATER OFF
OFF ON SYNC
OFF
ON-OFF-OFF = STANDARD REPEATER
OFF OFF
ON OFF MODEM ON-OFF-ON = AUTOMATIC REPEATER
ON ON N/U
ON
ON-ON-OFF = REPEAT ALL
ON ON
ROTARY SWITCH = 4 / RF PARAMETERS
1 2 3 4 5 6 7 8
RF BAUD RATE LISTEN BE-
FORE Tx
FEC
ON/OFF
ARQ
ON/OFF
RTS/CTS
HANDSHAKE
DSR/DTR
HANDSHAKE
ARQ
TIMEOUT
OFF OFF 4K
OFF ON 8K
OFF OFF OFF OFF OFF OFF
ON OFF 16K
ON ON N/U
ON ON ON ON ON ON
ROTARY SWITCH = 5 / SERIAL INTERFACE CONFIGURATION
1 2 3
SERIAL PORT
BAUD RATE
OFF OFF OFF 150
OFF OFF ON 300
OFF ON OFF 600
OFF ON ON 1200
ON OFF OFF 2400
ON OFF ON 4800
ON ON OFF 9600
ON ON ON 19200
4 5 6 7 8
PARITY CHARACTER
LENGTH
STOP
BITS
OFF OFF NONE OFF OFF 7 BITS OFF 1
ON OFF EVEN OFF ON 8 BITS ON 2
ON ON ODD ON ON 9 BITS