User manual

Smart_DP RM 9600 User Manual
Seite 14
Configuration of the Profibus-DP parameters:
Picture 3 – Configuration tool (DP configuration)
DP address: Shows the Profibus address stored in the EEPROM of the Smart_DP module.
This address is active, if the code switches are switched to a value above 126. In this case the
address can be changed during active bus operation mode by the master via a
'SetSlaveAdress-Telegram'. The changed address will then be stored in the EEPROM.
DP ident nr: Shows the used PNO-Ident number of the module.
Read: Reading of the parameters stored in the EEPROM.
Write: Writes the actual values to the EEPROM of the Smart_DP module – the settings are not
active before the next reboot of the Smart_DP module.
Important note:
If you are not sure what address should be used for connecting Smart_DP to your spe-
cial Profibus-DP network, please ask the engineer who is responsible for your bus sys-
tem.