User manual

Smart_DP RM 9600 User Manual
Seite 10
F.1 Configuration via code switches
The Profibus-DP address of Smart_DP can be configured via the code switches. This method
of setting the address has a higher priority than the configuration by software. By software the
address can be set through the 'SetSlaveAddress-telegram' of the master or by the serial con-
figuration tool described in the following sentences. The settings done by software are only
active if the code switches are switched to a value above 126. Otherwise, the hardware set-
tings have priority.
Important note:
A changing of the value of the code switches will only be active if the Profibus-DP/RS-
232 interface if booted again (that means the power supply is separated and then con-
nected again).
In any case:
If you are not sure what address should be used for connecting Smart_DP to your spe-
cial Profibus-DP network, please ask the engineer who is responsible for your bus sys-
tem.