User manual

Smart_DP RM 9600 User Manual
Seite 9
F - Configuration
In order to use the whole function of the Smart_DP device, some parameters must be set ac-
cording to the respective working scenario. The user has three possibilities to configure the
Profibus-DP/RS-232 interface:
 Set the bus address via the code switches
 RS-232 configuration software for setting the bus address parameter
 Configuration via the project tool of the respective master system through the
GSD file, and the 'SetSlaveAddress-telegram'
Profibus parameter RS-232 Profibus-
DP / GSD
Code
switches
Description
DP-address r/w r/w w Hardware address of Smart_DP
Serial Interface
Speed r/w r/w n.a. Baudrate
Bits r/w r/w n.a. Length of data word
Stop bits r/w r/w n.a. Stop bits
Handshake n.a. n.a. n.a. Handshake mode, not implemented
Parity r/w r/w n.a. Parity
Additional parameter
Serial number r n.a. n.a. Serial number
Firmware version number r n.a. n.a. Firmware version
(Legend: r read, w write, n.a. not available)
The table above shows, which parameters can be read or set by which tool.
Important note:
If the Smart_DP cannot be found in the Profibus network, the setting of the bus address
should in any case first be done by means of the code switches!