Installation guide

3
telephone line, contact the local telephone company. The REN for the EC6000i, EC7000i, or EC7500i Series Scanner is found on the underside
of the unit. The digits 00 are the REN without a decimal point (00 is the REN of 0.0).
The plug and jack used to connect this equipment to the premises wiring and telephone network must comply with the applicable FCC Part 68
rules and requirements adopted by the ACTA. A compliant telephone cord with modular plug is provided with this product. It is designed to
connect to a compatible modular jack that is also compliant. See the installation instructions for details.
If this equipment is equipped with a modem and causes harm to the telephone network, the telephone company will notify you in advance that
temporary discontinuance of service may be required. If advance notice is not feasible, you will be notified as soon as possible. When you are
notified, you will be given the opportunity to correct the problem and informed of your right to file a complaint with the FCC if you believe that
it is necessary. Contact your telephone company if you have any questions about your phone line.
Telephone Company Procedures: The goal of the telephone company is to provide you with the best service it can. In order to do this, it may
occasionally be necessary for them to make changes in their equipment, operations or procedures. If these changes might affect your services or
the operation of your equipment, the telephone company will give you notice, in writing, to allow you to make any changes necessary to
maintain uninterrupted service. Connection to party line service is subject to state tariffs. Contact the state public utility commission, public
service commission, or corporation commission for information. Connection to Telephone Company provided coin service is prohibited.
If the building where a modem-equipped RDM product is installed has specially wired alarm equipment connected to the telephone line, ensure
that the installation or operation of the modem does not disable your alarm equipment. If you have questions about what will disable alarm
equipment, consult your telephone company or a qualified installer.
CAUTION: Changes or modifications not expresssly approved by RDM Corporation could void the user’s authority to operate the
equipment.
All units covered by this manual have no user-serviceable parts inside. In the event repairs are ever needed to any RDM product, they should be
performed by RDM Corporation or an authorized representative of RDM Corporation. For information please contact RDM Corporation,
4-608 Weber Street North, Waterloo, Ontario, Canada N2V 1K4, at 1-800-567-6227, or RDM’s US service agent below.
US Service Agent
Jason S. Miller
[phone]
[e-mail]