User guide

EC9000i Series Scanner User Guide Setting up your scanner

Installing the franker cartridge

1. Disconnect the power cord from the scanner.

2. Remove the front of the scanner.

At the back of the scanner, the franker

cartridge is held in place by a blue franker

latch and a metal plate.

3. Lift the blue franker latch.

4. Pull the franker cartridge out of the scanner by

the franker tab.

5. Insert the new franker cartridge. Make sure

the metal plate fits into the franker cartridge

like in the picture above.

6. Push the franker cartridge into the scanner by

pushing in the metal plate and then lowering

the blue latch over the franker cartridge until it

snaps closed.

7. Replace the scanner cover.

Replacing the endorser inkjet cartridge

When you place the new inkjet cartridge into the holder, make sure that you insert it at the angle

described in the following steps. If you do not insert the cartridge properly, it might not make contact with

the document when it is scanned.

1. Disconnect the power cord from the scanner.

2. Remove the endorsement printer cover.

3. Pull the inkjet latch away from the printer cartridge.

4. Pull the inkjet cartridge out of the scanner.

Franker tab

Metal plate

Franker latch