Installation guide

16
Connecting the Power Cord
1. Align the flat side of the power connector so that it is facing up.
2. Insert the round end of the power cord into the power port on the back of the scanner.
Make sure that the connector is pushed in completely; it should click into place.
3. Plug the power connector into the power adapter.
4. Plug the metal-pronged end of the power adapter into an electrical power outlet.
The LED lights up, and cycles through red and green.
When the LED is solid green, your unit is powered on.
Disconnecting the Power Cord
The power connector has a sleeve on it that secures it to the unit. The security sleeve prevents the power connector from being
pulled out of the unit accidently.
1. Hold the unit in place with one hand to prevent the unit from falling.
2. With your other hand, slide the security sleeve on the power connector back.
3. While you hold the security sleeve back, firmly pull the power connector away from the unit until it is disconnected.
Drivers
The drivers for your scanner are installed when you install your PC application. There are many applications that support the
RDM Connect scanner; most are available from third-party vendors.
If you are not sure where to acquire your PC application, check with the reseller from whom you purchased your scanner, your
bank, or your service provider.
Caution:
Disconnecting the power source while the terminal is processing a transaction might cause data loss.