Installation guide

13
Replacing the Franking Acknowledgement Printer Cartridge
1. Remove the front cover.
2. Lift the franker latch.
3. Grasp the tab on the franker cartridge and lift it up and out.
4. Insert the new franker cartridge by aligning the hole on the back of the cartridge with the metal plate.
5. Make sure that the franker cartridge is in an upright level position so that the franker latch can close over it.
You might have to push the metal tab in gently to allow the franker latch to swing properly over the franker cartridge tab.
6. Lower the latch over the franker cartridge, and then gently press the latch down until it snaps into the closed position.
7. Replace the front cover.