Installation guide

11
Removing the Covers
RDM Connect scanner has two covers that can be removed in order to clean the image sensor, replace cartridges, or clear paper
jams.
Front Cover
Remove the front cover when you need to clear paper jams, replace
the franker cartridge, or to clean the image sensor.
1. Pull the extension forward.
2. Grasp the front and the back end of the front cover.
3. Gently pull the cover upwards until it detaches from the
scanner.
To replace the front cover:
1. Make sure the extension is pulled out.
2. Carefully place the front cover over the scanner assembly; make sure that the cover is overlapping the assembly correctly.
3. Gently push the cover down until it snaps into place.
Caution:
Before you replace the front cover, make sure the extension is
pulled forward; otherwise, you might damage the front cover.