Installation guide

23
Check Feeder Does Not Function Properly
Ensure that you are inserting the check properly: flush to the right
side of the EC6000i, the EC7000i, or the EC7500i, information-side
facing up, with the MICR line to the inside right. If the problem
persists, contact your distributor. Remove any debris by following
the directions below:
1. Press the latch and lift the cover to access the imaging
frame.
2. Lift the imaging frame to access
the document feed plate.
3. Clear any paper or debris from the
imaging frame and document feed
plate.
4. Ensure that the black fingers on
the baffle move freely (EC7000i
and EC7500i only).
5. Use a lens-cleaning tissue or a damp, lint-free cloth to
remove any ink or dust from the document sensors.
6. Ensure that the rollers under the baffle are clean.
7. Close the imaging frame and cover.
Document
Sensors
Rollers
Black
Fingers