Installation guide

16
Status Signals for EC6000i and EC7000i
The scanner comes equipped with the default light and sound signals described below.
EC6000i/EC7000i Default Light Signals
The unit’s status is shown through a single, multi-state LED (light-emitting diode), which is the light on the
top, front, right-hand side of the unit. The table below describes typical status signals and their meanings.
LED Meaning; What To Do
Green Solid The unit is ready to accept a check; insert a check.
Green Flashing The unit is busy, processing the last check; wait for the job to finish.
Amber Solid The unit is idle; start the next job with a command from the terminal or PC
application.
Amber Flashing The unit is sending or receiving information from the terminal or PC
application; wait.
Red / Green / Amber Flashing The unit is starting up or performing diagnostics; wait.
Red Solid The unit failed during a self-test; check the terminal display for instructions /
refer to your local procedures / call you distributor (reseller).
Red Flashing An error occurred during processing. See “Default Sound Signals” on the
next page for details; check the terminal display for instructions / refer to your
local procedures / call your distributor (reseller).