Specifications

RDM Communicator

1. Introduction

The RDM Communicator is a multi-functional interface for ROBE and Anolis fixtures. This device allows to set

parameters (DMX address, DMX mode...etc) for Anolis non-display fixtures (like ArcPad Xtreme, ArcPad 48

Integral). The RDM Communicator also enables remote fixture status monitoring, fixture detection, fixture

parameter setup and can be used in combination with any Robe/Anolis fixtures which support RDM protocol.

Main features:

- Connection to any Robe/Anolis fixture with RDM protocol

- Possibility to set multiple fixtures in serial DMX chain

- Graphic touch screen for fixture setting and addressing

- 4 operational buttons

- Battery operated

- No extra PSU needed (only for charging the battery)

- Rugged aluminium housing

- RDM Out

- Ethernet input

2. Device exterior view

1- RDM Out (5-pin XLR, female) 6- ESCAPE button

2- RDM Out (3-pin XLR, female ) 7- NEXT button

3- Ethernet (RJ 45) 8- PREV button

4- Charging connector 9- ENTER button (Power on/off)

5- Graphic touch screen 10- Sliding eye (to hang device e.g. on belt)