Brochure

Connect Twisted Pair Cable
directly to the output of a
FORMAT A SENDER.
REAR
D SERIES - PSP1A
ACB
PAIR
FORMAT A
TP CABLE
Adjust
gain for
the
desired
listening
level from
the
speaker.
FRONT
Set switch to
determine
which of the
three
FORMAT-A
pairs is
amplified.
ACCESSORIES
Models D-PSP1A, DB-PSP1A, DG-PSP1A, DS-PSP1A
Decora-Style Active Loudspeaker - Format-A
TYPICAL PERFORMANCE
Input: RDL Format-A
Input Connection: RJ45
Format-A Signal Pair Used: Switch-selectable A, B, or C (Rear-panel)
Gain Adjustment: Single-turn audio taper (Front-panel)
Maximum SPL: 81 dB
Frequency Range: 150 Hz to 20 kHz, nominal
CMRR: > 80 dB (50 Hz to 120 Hz)
Power Requirement: 24 Vdc @ 55 mA (Idle); 100 mA (maximum), Ground-referenced
Ambient Operating Environment: 0° C to 40° C Maximum; 20° C Recommended
Dimensions: Height: 4.13 in. 10.49 cm; Width: 1.7 in. 4.32 cm; Depth: 2.05 in. 5.21 cm
Installation/Operation
EN55103-1 E1-E5; EN55103-2 E1-E4; EN60065
Typical Performance reflects product at publication time exclusive of EMC
data, if any, supplied with product. Specifications are subject to change
without notice. This product is Professional Apparatus.
Radio Design Labs Technical Support Centers
U.S.A. [phone], [phone]; Fax: [phone]
Europe [NH Amsterdam] (++31) 20-6238 983; Fax: (++31) 20-6225-287
891-5665
Tab on bottom of connector
(1) + White / Green
(2) – Green
(3) + White / Orange
(4) – Blue
(5) + White / Blue
(6) – Orange
(7) + White / Brown
(8) – Brown
Pair A: Audio +4 dBu
Pair B: Audio +4 dBu
Pair C: Audio +4 dBu
Pair D: Power +24 Vdc
RJ45 Standard wiring
RJ45 conductor colors shown are for 568A standard.
The 568B standard may be used if the connectors at
both ends of the cable are wired identically.