Installation Guide

9
ENGLISH
3.
If installing at an angle between 35 and 38
degrees, snap a small insert (F.B) into each
bottom bracket (Fig. 6).
If installing at an angle between 32 and 34
degrees, lower snap a large insert (F.A) into
each bottom bracket (Fig. 7).
4.
Orient the bracket being used at the top of
the stair with the insert placed inside the
bottom of the bracket and the bracket being
used at the stair bottom with the insert at the
top of the bracket (Fig. 8).
Slide the brackets onto the rail with the
bracket’s at side facing the rail ends. Set rail in
place and pre-drill at all holes in the mounting
brackets to avoid stripping the stainless steel
screws (Fig. 9) and secure in place using item
K from component list (Fig. 10).
NOTE: The looped part of the aluminum
P-channel must be facing away (down)
from the baluster holes; the at side of the
P-channel must be facing the outside of the
deck when mounted.
5.
Insert a baluster into each of the rst and last
baluster holes of the bottom rail, and set the
top rail in place by inserting them into the
corresponding holes (Fig. 11).
Place the top rail inside of the posts to measure
accurately. Adjust for plumb.
Trace the posts onto the rail and mark
1
/
8
" short
to allow for expansion (Fig. 12).
(Fig. 7) (Fig. 10)
(Fig. 11)(Fig. 9)
(Fig. 8)
(Fig. 6)
Bracket used at
Top of Stair
Bracket used at
Bottom of Stair
(Fig. 12)