Installation Guide

5
ENGLISH
(Fig. 11)
(Fig. 12)
7.
Cut the top rail following the same
procedure that you used in steps 3 and 4
for the bottom rail.
8.
Place a T-shaped top mounting bracket (item
F) on each end of the top rail, with the at
side facing the mounting surface.
Make sure that the aluminum T-channel is
ush with the end of the vinyl top rail (Fig. 11).
9.
Beginning at one end of the rail section,
(Fig. 12) insert each baluster installed in Step
6 into the corresponding baluster hole into
the top rail.
To allow for baluster expansion, raise the top
rail approximately 1/8". Pre-drill the holes (Fig.
13) for the mounting brackets to avoid stripping
the stainless steel screws and secure in place
using supplied screws (I) (Fig. 14).
(Fig. 13) (Fig. 14)