Installation Guide

4
ENGLISH
4.
Cut each end of the rail at the measurement
determined in Step 3 (Fig. 5).
Tip: If using a power saw, a carbide tip blade
of at least 60 teeth is recommended.
Place a bottom mounting bracket on each
end of the bottom rail with the at side facing
the rail ends (Fig. 6).
5.
Place rail with brackets between posts as
shown in Figure 7.
Pre-drill the holes (Fig. 8) for the mounting
brackets to avoid stripping the stainless steel
screws and secure in place using the rail
mounting screws (item I) from component list
(Fig. 9).
NOTE: The looped part of the aluminum
P-channel must be facing away (down) from
the baluster holes while the at side of the
P-channel must be facing the outside of the
deck when mounted.
6.
Insert a baluster into each routed hole of the
bottom rail (Fig. 10).
NOTE: Each kit with vinyl balusters contains
2 tabbed balusters; space them evenly into
each section.
LEVEL RAIL CONTINUED
(Fig. 5)
(Fig. 6)
(Fig. 8) (Fig. 9)
(Fig. 10)
(Fig. 7)