User's Manual

Frequency Range: 418 MHz
Typical Range Open air (line of sight): 200 feet (60 m)
Typical Range Indoors: 60 feet (18 m)
Sensor size: 3.43"L × 1.61"W × 0.59"H (87mm × 41mm × 15mm)
Wall Mount Drilling Template
Mounting tools: Screwdriver, electric drill or awl. On hard surfaces, XANBOO recommends that you pre-drill ½-inch
deep pilot holes with a drill bit slightly smaller than the bracket mounting screws before securing the bracket to the
surface. When mounting a sensor on soft surfaces like sheetrock, use an awl to punch holes in the material slightly
smaller than the plastic anchors included in the hardware mounting kit.
The illustration is drawn to a one-to-one scale, which means that it provides the exact dimensions required to mount
the unit.
Troubleshooting
Problem
LED does not light up
Wireless System Controller does not recognize the sensor during discovery
Events are not triggered
Sensor continually sends an event
Solution
Ensure the batteries are properly inserted with the correct polarity.
Ensure you are using new AAA batteries.
Ensure sensor is powered. Position the sensor in closer proximity to your Wireless System Controller and try again.
Ensure there are no other wireless devices interfering with the sensor. The sensor transmits on the 418 MHz frequency.
Is the sensor registered with your Wireless System Controller?
Ensure that you have the proper settings configured for the sensor
Ensure that you have the proper settings configured for the sensor. For example, you have armed the sensor.
The sensor can be configured so that it can send an event when the contacts are closed or when they are opened.