User's Manual

ManualsBrandsRDI Technology ManualsElectronicsWALL MOUNT STAIRWELL LED LIGHT

Stairw

Stai

back



Req



XASW02

well Light Specifi

verview

irwell LED

kup, and RF

oal

Compli

Vandal-

Easy to

Occupa

Wireles

Battery

quireme

Use occ

dim

Max Po

Ability

Use wir

and

sam

Battery

8-1

Test sw

Dis

WALL MOU

ication.docx

lighting com

F system for

iant with AS

iant with NY

-resistant

install

ancy Sensor

ss RF system

backup

ents

cupancy sen

djustable tim

mmed(Rang

ower 40W

to work wit

reless RF sy

e rotary (sc

d Floor Num

Sta

ccupancy on

me Stairwel

backup

perate for 90

ccupied & R

12H battery

witch

sconnects m

UNT STAIR

mpliant wit

r linking mu

SHRAE 90.

YC LOCAL

m to link mu

nsor to redu

meout (after

ge 15 Secon

th wireless

ystem to link

crewdriver s

mber (00-99

airwell Num

n one floor t

ll.

0 minutes at

RF functiona

charge tim

main supply

RWELL LE

12/4/12

th modern st

ultiple light

1-2010

L LAW 47

ultiple fixtu

uce lighting

r last occup

nds to 15 Mi

remote PIR

k fixtures

set) switche

mber

triggers one

t 50% light

ality the sam

via relay (o

ED LIGHT

tandards, w

ts.

ures for occu

to 6W when

pancy, light l

inutes)

R (To be dev

es on fixture

e floor abov

output

me as while

on 10VDC l

User Manual

SPECIFIC

DA TE:

with occupan

upancy sens

n unoccupie

level return

veloped late

e to set Stai

Floor Num

e and one fl

on mains (

line) for 30

CATION

ncy sensor,

sing

ns to

er)

rwell Numb

mber

floor below

dimming).

seconds (o

Page 1 of 4

battery

ber (0-F)

within

r more

Summary of content (6 pages)

PAGE 1
User Manual W WALL MOU UNT STAIR RWELL LE ED LIGHT SPECIFIC CATION XASW02 DA TE: Ovverview Staiirwell LED lighting com mpliant witth modern sttandards, w with occupanncy sensor, battery back kup, and RF F system forr linking mu ultiple lightts. Go oal  Compliiant with AS SHRAE 90.
PAGE 2
TECHNICAL DOCUMENT TITLE: REVISION:     WALL MOUNT STAIRWELL LED LIGHT SPECIFICATION 2.4 DATE: 4/5/2013 if pressed for longer). Controller monitors battery voltage etc and returns status of test on test LED.
PAGE 3
TECHNICAL DOCUMENT TITLE: REVISION: WALL MOUNT STAIRWELL LED LIGHT SPECIFICATION 2.4 DATE: 4/5/2013 Functional Specification Normal (AC mains) operation  LEDs always on at 6W level  Occupancy sensed – LEDs on to Max power with adjustable timeout.  RF system (Microcontroller) broadcasts occupancy sensing to all fixtures on same channel code – all fixtures respond to all occupancy events.  Battery charging Microcontroller monitors battery, applies maintenance trickle charge when fully charged.
PAGE 4
TECHNICAL DOCUMENT TITLE: REVISION:     WALL MOUNT STAIRWELL LED LIGHT SPECIFICATION 2.4 DATE: 4/5/2013 RF system – same as on AC. Test switch Non-operational Test LED – bi-color Red/Green Indicates status of last test – see function table above Status LED – bi-color Red/Green See function table above RF operation    Three encoders Encoder one actually sets one of 16 RF channels Encoder two and three sets an 8-bit address.
PAGE 5
TECHNICAL DOCUMENT TITLE: REVISION: WALL MOUNT STAIRWELL LED LIGHT SPECIFICATION 2.4 DATE: 4/5/2013 Mechanical End caps to comply with UL HB or ar required by UL/NFPA End cap Color Gray similar to Pantone 429U Stairwell Light Specification.
PAGE 6
FCC NOTE： This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS OR CHANGE TO THIS EQUIPMENT. SUCH MODIFICATIONS OR CHANGE COULD VOID AND CHANGE ANNTENA WHICH THE MANUFACTURER PROVIDES.