User's Manual

4
Step Description Image
1
Removethefixturefromthepackagingandmakesureithas
arrivedingoodcondition.Placethefixtureonaflatsurfaceand
removetwoscrewswhichsecuretheback‐boxtothelight
engine(locatedoneithersideofthefixtureinthemiddleand
justbehindthelens).
2
Useastraightslotscrewdriverandgentlyprythesheetmetal
awayfromthelightengine.Thereisanotchdesignedintothe
backboxforthispurpose.Thiswillreleasetheprimarylight
enginefromthebackbox(white).
3
Carefullyremovetheprimarylightengineandsetit
nexttothe
backbox.Therearetwoconnectorsthatmustbedisconnected.
Thelargerofthetwoconnectorsisforthemotionsensorarray.
Thesmallerconnectorpowersthelightengine.
4
Afterremovingtheexistingfixturefromtheceiling,positionthe
newbackboxwhereyouwantit.Usingthe
providedopenings,
securethebackboxtotheimbeddedjunctionbox(ifpoweris
cominginfromthebackofthefixture).Checkthealignmentof
thebackboxandthensecuretheendsofthefixtureusingthe
providedholes.AnanchororTapconisrecommended,ensuring
thatthis
iscompliantwithlocalcodesandordinances.Note:
Usewashersasspacersiftheceilingisnotflat.Notdoingsocan
resultinawarpingofthebackbox,makingitdifficulttosnapin
theprimarylightengine.
5
Ifinstallinganemergencyback‐upbattery,usaPhilips
screwdriver
toremovethebatteryholdingfixtureclosesttothe
driver.
Installation
XeleumLighting,LLC.333NorthBedfordRd.MountKisco,NY10549*Phone954‐617‐8170*Fax954‐571‐9777*www.xeleum.com
ArtemisSeriesofLowOccupancyLED
CeilingMountedFixtures(IncludingStairwells)
Installation&OperationGuide
4